fast search
The microphones M 294 and M 295 extend the studio microphone System SMS 2000. The proved microphone capsules M 70 and M 94 form a unit with the modified microphone amplifier MV 200.
These microphones are designed for a universal application in professional recording and sound reinforcement and meet the requirements of modern technics.
The newly developed, transformerless circuit design substitutes the previous transformer by a symmetrical output stage. The low intrinsic noise and a remarkably output capability emphasize the advantages of the microphone capsules M 94 and M 70. Microphone capsules with an extremly thin metal diaphragm are very impressive because of its brilliant sound transmission.
The direction of maximum sensitivity is axial. The studio microphones are equipped with a comprehensive range of accessories for widely varying methods of microphone mounting.
lt is possible to switch on a 10 dB-preattenuation for the handling of very high sound pressure levels. A reduction of the sensitivity factor for low frequencies can be utilized to suppress the proximity effect. The two switches are sunk placed in the middle of the amplifier.
At the lower end of the amplifier a 3-pin XLR connector is placed for the C 70 microphone cable. The power supply is provided by 48 V phantom powering, which is internationally standardized as P 48 in DIN 45596 and IEC 268-15.
The studio microphones are available with the finish matt black and satin nickel.
Both condenser microphone capsules operate as pressure gradient transducer. The converter elements contain nickel diaphragma with a thickness of less than 1 µm. The teflon-coated back electrodes serve to increase performance reliability.

 

high resolution high resolution
 
The desired treble boost rising of nearly 5 dB at about 8 kHz gives this microphone its special clarity.
 
The frequency response in the upper range is virtually linear, while in the Iower frequency band it features a slight roII-off to counteract the bass lift of dose speech (proximity effect). The microphone is thus ideally suitable for recordings in dose proximity to the sound source.

lt is recommendable at close-talking to use a close-speech screen and to switch on the bass rolI-off on the amplifier. In order to get a life-like recording on Iocation a wind screen should be utilized.

Microphone M 294 in a wooden case
L x B x H   210 x 68 x 50 mm
satin nickel
Order-No. 211112
black matt
Order-No. 211113

Microphone M 295 in a wooden case
L x B x H   210 x 68 x 50 mm
satin nickel
Order-No. 211114
black matt
Order-No. 211115

Windscreen, anthracite
W 71
Order-No. 202405
Popscreen, black
PO 70
Order-No. 600018
Microphone holder, satin nickel
Microphone holder, dark bronze
MH 93
MH 93
Order-No. 202325
Order-No. 202326
Elastic suspension, satin nickel
Elastic suspension, black matt
EA 20
EA 20
Order-No. 202308
Order-No. 202311
Elastic suspension, satin nickel
Elastic suspension, dark bronze
EH 93
EH 93
Order-No. 202327
Order-No. 202328
Table stand, satin nickel
Table stand, black matt
TS 64
TS 64
Order-No. 212303
Order-No. 212308
Double mount, satin nickel
Double mount, dark bronze
TD 93
TD 93
Order-No. 202331
Order-No. 202332
Gooseneck, black
ME 90
Order-No. 202324
Power supply
N 200
Order-No. 202101
Connection cable
C 70
Order-No. 202212

Condenser Studio Microphones
Type
M 294
M 294
Polar pattern
cardioid
cardioid
Acoustical operating principle
Pressure gradient transducer
Frequency range
40 ... 18000 Hz
40 ... 18000 Hz
Sensitivity at 1 kHz
17 mV / Pa
17 mV / Pa
Switch position "reduced bass roll-off" at 60 Hz
-15 dB
-15 dB
Rated impedance
150 
150 
Equivalent loudness level
due to inherent noise
CCIR 468-4
22 dB
22 dB
DIN EN 60651
13 dB - A
13 dB - A
Signal-to-noise-ratio
(re. 1 Pa at 1 kHz)
CCIR-weighted
72 dB
72 dB
A-weighted
81 dB
81 dB
Max. SPL for THD 0,5 %
133 dB
133 dB
with 10 dB preattenuation
143 dB
143 dB
Total dynamic range of the microphones amplifier
120 dB
120 dB
Current consumption (P 48, DIN 45596, IEC 268-15)
3 mA
3 mA
Output connector
3-pin XLR-connector
goldplated contacts
Weight
160 g
160 g
Dimensions (L x )
166 x 21/25 mm
166 x 21/25 mm
next side